Remounting the EMF actuator
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Release screws (1) and remove the EMF actuator (2).
- Carefully put on the EMF actuator until the gearing snaps in and the EMF actuator is flush with the brake caliper.
- If necessary, turn the EMF actuator slightly until the hole and the screw thread are aligned.
- Replace screws 1.
Parts: Screws
- Position and tighten the screws (1) at the EMF actuator (2).
TIGHTENING TORQUE SPECIFICATIONS
| EMF actuator to brake caliper | ||
| Replace screws. | Tightening torque | 8 Nm |