Installing the front brake discs

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.

Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
Mount brake disc (2).
Position and tighten the screw (1).
Replace screw.

Parts: Screw

TIGHTENING TORQUE SPECIFICATIONS

Brake disc to front wheel hub
M8 Replace screw.	Tightening torque	16 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Install the caliper carrier (2) in the direction of the arrow.
Replace screws.
Parts: Screws
Insert screws (1) and tighten.

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Brake caliper/brake anchor plate at front swivel bearing
M12 Replace screw.	Tightening torque	130 Nm

Follow-up work

Refer to GREASE THE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER USING BRAKE PAD PASTE (17 INCH BRAKE) .
Refer to INSTALLING THE FRONT BRAKE PADS .
Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
Refer to COMMISSIONING/BEDDING IN (BRAKE) NEW BRAKE PADS AND BRAKE DISCS .