Installing the boost pressure sensor on the intake plenum
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Check the sealing ring (1) for damage, replace if necessary.
- Coat sealing ring (1) of boost pressure sensor thinly with lubricant.
TIGHTENING TORQUE SPECIFICATIONS
| Boost pressure sensor to intake plenum | ||
|---|---|---|
| Torx screw 6x20 | Tightening torque | 5 Nm |
| Hexagon bolt 6x20 | Tightening torque | 8 Nm |
- Guide in and insert charging pressure sensor (3) on the intake air plenum.
- Tighten down screw (2).
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.