Replacing the throttle body

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .

Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
Read and comply with user information on using the associated special tool 12 7 060.
Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Loosen screw (1).
Remove the boost pressure sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Check sealing ring (1) for damage, replace boost pressure sensor if necessary.
Parts: Boost pressure sensor

Courtesy of BMW OF NORTH AMERICA, INC.
Prior to installation, apply a thin coat of lubricant to the sealing ring (1) of the charging pressure sensor.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the boost pressure sensor (2).
Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Boost pressure sensor to throttle body
TS5x20	tightening torque	5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.