34 41 220 Removing and installing/replacing all parking brake shoes (2' Series coupe and convertible, 2017-2021)

Special tools required: 

• 32 1 030 
• 34 4 000 
• 00 9 317 

Necessary preliminary work: 

• Refer to REMOVING  rear brake disk.

If applicable unclip the gaiter (1) with special tool 00 9 317  at top.

Installation note: 

First insert the gaiter (1) on the bottom and then clip in on the top.

Courtesy of BMW OF NORTH AMERICA, INC.

Lock adjustment unit (ASZE).

Actuate parking brake lever. Connect special tool 32 1 030  . Press limit position (1) of adjusting spring back to such an extent that retaining hook (2) engages in limit position (1).

Installation note: 

Unlock adjustment unit (ASZE).

Lever out restraining hook (2) with a suitable screwdriver.

Restraining hook (2) must detach from limit position (1) of adjusting spring.

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation note: 

Return spring (1) must not be overelongated.

Check and if necessary replace return spring (1).

Pay attention to installation position of adjusting screw (2).

Apply a thin coat of GREASE to bush and screw threads

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation note: 

Return spring (1) must not be overelongated.

Check and if necessary replace return spring (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Twist roll pins (1) 90° with special tool 34 4 000  and detach.

Remove brake pads (2).

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: 

• Refer to ADJUSTING PARKING BRAKE .