Install the wiring harness section for the transmission
- Route the wiring harness section for the transmission (1) and secure it with the clamps (arrows).
- Route the wiring harness section for the transmission (3) and secure it with the clamps (arrows).
- Tighten down screws (2).
TIGHTENING TORQUES SPECIFICATION
| Wiring harness section for transmission to cylinder head | ||
| M6x16 | Tightening torque | 8 Nm |
- Connect and audibly lock the connector (1) to the transmission.
- For all-wheel drive vehicles, connect the connector to the transfer box (VTG) and lock it audibly.
- Route the cable (2) and secure it with the clamps (arrows).
- Tighten the nut (1) (terminal 50).
TIGHTENING TORQUES SPECIFICATION
| Terminal 50 to starter motor | ||
| M6 hexagon nut | Tightening torque | 7 Nm |
- Connect the connector (1), it should lock audibly.
Follow-up work
- Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) .
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT .
- Refer to INSTALLING TRANSMISSION CROSS MEMBER .
- Refer to INSTALLING TRANSMISSION CROSS MEMBER .
- Refer to MOUNTING THE PROPELLER SHAFT AND CENTER MOUNT .
- Refer to INSTALLING THE EXHAUST SYSTEM .
- Refer to INSTALLING THE SUPPORT FOR THE UNDERBODY PROTECTION .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE FIREWALL UPPER PART .
- Refer to INSTALLING THE TENSION STRUT ON THE STRUT TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .