Installing the transmission bearing support (all-wheel drive vehicle)

• Install transmission bearing support holder (3). 
• Tighten screws (2)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Transmission bearing support to body
  M8	Tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rubber mount to transmission bearing support
  M8	Tightening torque	19 Nm

• Install the retaining plate (2)  .
• Tighten nuts (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Retaining plates for vehicle underbody cover
  Sheet metal nut/plastic nut Replace nuts.	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING REAR UNDERBODY PROTECTION .