Remove output shaft
Preliminary work
- Refer to REMOVING THE FRONT LEFT WHEEL .
- Refer to IF INSTALLED: REMOVING THE HUB CAP .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to REMOVING THE COVER IN ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE LATERAL HOOD SEAL .
- Refer to PARTIALLY DETACHING FRONT AIR SUSPENSION .
- Refer to REMOVING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to DETACHING THE UPPER WISHBONE FROM THE SWIVEL BEARING .
- Refer to ATTACHING SWIVEL BEARING IN INSTALLATION POSITION .
- Refer to REMOVING THE SPRING STRUT HOLDER .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to REMOVING THE FRONT THRUST FIELD .
- Refer to REMOVING REAR THRUST FIELD .
- Secure output shaft against falling out.
- Position the aluminum mandrel (2) at the output shaft (1) (arrow).
- Knock out the output shaft (1)
out of the front axle transmission or the bearing bracket with the aluminum mandrel (2)
.
- Remove the output shaft (1) in the direction of the arrow.