Install the front holder for the intake plenum
- Position the holder (2)
and clip the wiring harness (1)
into the holder (2)
.
- Position the holder (5) and join the screws (4) .
- Join the screw (3) .
- Tighten down screws (3)
and (4)
.TIGHTENING TORQUE SPECIFICATIONS
Throttle body to holder M6X25 Tightening torque 8 Nm TIGHTENING TORQUE SPECIFICATIONSIntake plenum holder on engine BM6x16 Tightening torque 10 Nm - Clip in the wiring harness (1) and (2) at the holder (5).