Installing the vibration damper
- Clean the contact surface of the central bolt (7 ).
- Align and position vibration damper for the Woodruff key of the sprocket wheel.
- Position shim (4 ).
- Position fitting sleeve (2
).
The grooves (6 ) of the fitting sleeve (2 ) must point to the counter support (5 ).
- Position counter support (5 ).
- Tighten the screws (1 ) and (3 ) hand-tight.
- Replace central bolt (2
).
Parts: Central bolt
- Treat the contact surface (1
) of the central bolt (2
) with lubricating grease.
Consumable Lubricating grease SYNTHESO GLEP 1 100 g, Tube 83239407778 - Tighten central bolt (7
).TIGHTENING TORQUE SPECIFICATIONS
Central bolt Screw M18x1.5x122 Replace screw. Replace screws grease screw head see Consumables 4.8 Joining torque 100 Nm 1. Angle of rotation 60° 2. Angle of rotation 60° 3. Angle of rotation 60° - Release the counter support (5 ) and the shim (4 ) with the screws (1 ).
- Release the fitting sleeve (2 ) and counter support (5 ) with the screw (3 ).
- Remove the counter support (5 ) from the vibration damper.
- Remove the fitting sleeve (2 ).