Installing starter motor
CAUTION:
Improper routing of the positive battery cable.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
- Insert and install the starter motor (2) .
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Starter motor to engine | ||
|---|---|---|
| M8X60 | tightening torque | 19 Nm |
- Insert and install the acoustic cover of the oil sump (3) .
- Secure clamps (1) .
- Connect and lock the clamp (2)
.
The clamp (2) must engage audibly.
- Insert and install cable (3) .
- Connect and lock the clamp (2) .
- Connect and lock the clamp (1)
.
All clamps must engage audibly.
- Insert and install cable (1) .
- Fasten and lock the clamps (arrows).
All clamps must engage audibly.
- Connect cable (1) to the starter motor.
- Tighten nut (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Terminal 50 to starter motor | ||
|---|---|---|
| M6 | Tightening torque | 7 Nm |
- Feed the positive battery cable (3) in on the starter and install.
- Install the anti-twist lock (4) of the positive battery cable to the starter motor up to the stop (5) .
- Tighten nut (6) .
TIGHTENING TORQUE SPECIFICATIONS
| Battery positive lead to starter | ||
|---|---|---|
| M8 | tightening torque | 13.5 Nm |
Follow-up work
- Refer to INSTALLING THE REAR THRUST FIELD .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ONLY DURING STARTER MOTOR REPLACEMENT FOR VEHICLES WITH AUTOMATIC ENGINE START-STOP FUNCTION (MSA) .