Installing the holder for the electrical machine electronics
- Renew screws (1)
.
Parts: Screws
- Position the holder (2) for the electrical machine electronics on the electrical machine electronics (3) .
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Holder for electrical machine electronics (ELE) to electrical machine electronics (ELE) | ||
|---|---|---|
| M6x30 Renew screws. |
Joining torque | 8 Nm |
| Angle of rotation | 90° | |
- Clip in the positive battery cable on the holder (2) for the electrical machine electronics.
- Renew screws (1)
.
Parts: Screws
- Position the holder (2) for the tension relief on the electrical machine electronics (3) .
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Holder for tension relief to electrical machine electronics | ||
|---|---|---|
| M6 Renew screws. |
Joining torque | 4 Nm |
| Angle of rotation | 45° | |