Install the front underbody protection or front thrust field
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Version A:
Insert the front underbody protection (1).
Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Underbody protection | ||
| screw | Tightening torque | 3 Nm |
- Version B:
Position the front stiffening plate (1).
Replace screws (2).
Parts: Screws
Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to front axle support | ||
| M8 Replace screws. |
Joining torque | 25 Nm |
| Angle of rotation | 70° | |
- Tighten down screws (3).
- Tighten down screws (4).
TIGHTENING TORQUE SPECIFICATIONS
| Underbody protection | ||
| screw | Tightening torque | 3 Nm |