Install front stiffening plate
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Replace screws (2)
.
Parts: Screws
- Position stiffening plate (1) .
- Tighten down screws (2) .
TIGHTENING TORQUES SPECIFICATION
| Thrust field to front axle support | ||
| M8 Replace screws. |
Joining torque | 25 Nm |
| Angle of rotation | 70° | |
- Tighten down screws (3) .
TIGHTENING TORQUES SPECIFICATION
| Thrust field to holder | ||
| M6 | tightening torque | 2.3 Nm |
- Tighten down screws (4) .
TIGHTENING TORQUES SPECIFICATION
| Underbody protection | ||
| screw | tightening torque | 3 Nm |