Installing the right-hand charge air pipe

• Replace the molded seal.

  Parts:  Molded seal

• Position the charge air duct (4).
• Tighten down screws (3).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Charge-air tube to turbocharger
  M6x16	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the plug connection (1).
• Clip in the cable clip (2) at the charge air duct (4).

Follow-up work 

• Refer to INSTALLING TOP RIGHT CLEAN AIR PIPE .
• Refer to INSTALLING THE RIGHT THROTTLE BODY .
• Refer to INSTALLING THE CENTER COWL UPPER PART .
• Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
• Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .