Install rear underbody protection
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Version A:
Insert the rear underbody protection (1).
Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield | ||
| screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
- Version B:
Feed in rear underbody protection (1) and install.
Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield | ||
| screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
- Version C:
Feed in rear underbody protection (1) and install.
Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield | ||
| screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |