Removing intake silencer housing
WARNING:
High-voltage system.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
- All work on the high-voltage system may only be carried out by specially trained and technically experienced personnel.
- For additional information see:
- For additional information see:
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
- Unlock and loosen connector (1).
- Unfasten clamp (2).
- Remove screws (arrows).
- Remove the upper section of the intake filter housing (3).
- Remove the air filter insert (1).
- Loosen screw (1).
- If installed: Unlock and loosen the clamps (2).
- Pull the intake silencer housing lower part (3) up and out of the rubber mount and remove it.