1165 CHARGER WITH CONTROL (740e PHEV xDrive 2017-2019)
1165 TIGHTENING TORQUE OVERVIEW
| Electrical controller drive to exhaust turbocharger | ||
| screw | Tightening torque | 2.5 ± 0.5 Nm |
| Electrical controller drive to exhaust turbocharger | ||
| Replace screws. Tighten screws crosswise. |
Tightening torque | 3 ± 0.5 Nm |
| Heat shield to cylinder head | ||
| M8x12 | Tightening torque | 19 Nm |
| Heat shield to cylinder head | ||
| M8 x 12 | Tightening torque | 19 Nm |
| Heat shield to trim strip | ||
| M6x12 | Tightening torque | 8 Nm |
| Heat shield to trim strip | ||
| M6 x 12 | Tightening torque | 8 Nm |
| Wastegate valve controller control rod | ||
| Always use a second open-end wrench (for counter support) to tighten the lock nut! | Tightening torque | 6 ± 0.3 Nm |
11 65 EXHAUST TURBOCHARGER WITH CONTROL - TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Heat shield to cylinder head | B42S20O0/B46M0/O0/B48M0/O0 | M8x12 | 19 Nm | |
| 2AZ Heat shield to trim strip | B42S20O0/B46M0/O0/B48M0/O0 | M6x12 | 8 Nm | |
| 3AZ Electrical actuator drive for wastegate valve to exhaust turbocharger | B42S20O0/B46M0/O0/B48M0/O0 | M4 | Screw with washer | 2.5±0.5 Nm |
| M4 | Screw without washer | 1.9±0.2 Nm | ||
| 4AZ Linkage to electrical controller drive for wastegate valve | B42S20O0/B46M0/O0/B48M0/O0 | Tighten nut using only a second open-end wrench (to hold up). | 6±0.3 Nm |