64 53 517 Replacing desiccant insert for air conditioning system

Special tools required:

00 9 030

WARNING: Danger of injury!
Refrigerant circuit is under high pressure!
Follow safety informations for handling R 134a refrigerant . See 64 50... NOTE FOR HANDLING R134A REFRIGERANT or 64 50... SAFETY INFORMATIONS FOR HANDLING TETRAFLUORETHANE REFRIGERANT R134A .
Follow safety instructions for HANDLING REFRIGERANT OIL .
Avoid contact with refrigerant and refrigerant oil.

IMPORTANT: Risk of damage!
Restart engine only when A/C system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit.
If air conditioning system is opened for more than 24 hours: replace desiccant insert for air conditioning system

Follow INSTRUCTIONS ON REPLACING DESICCANT INSERT .

Necessary preliminary tasks:

DRAIN OFF AIR CONDITIONING SYSTEM
Remove UNDERBODY PROTECTION .

NOTE: Pictured in removed state.

The condenser does not need to be removed for the following operations!

Remove protective cap (1) from capacitor (2).

Fig 1: Identifying Protective Cap And Capacitor

G06886377

Courtesy of BMW OF NORTH AMERICA, INC.

Press sealing cap (1) inwards and remove circlip (2).

Fig 2: Pressing Sealing Cap

G04761899

Courtesy of BMW OF NORTH AMERICA, INC.

With assistance of a screwed-in screw (1), remove sealing cap (2) from capacitor (3).

Fig 3: Removing Sealing Cap From Capacitor

G04761900

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing rings (1).

Use special tool 00 9 030 to fit sealing rings (1) without damaging them.

Fig 4: Identifying Sealing Rings

G04761901

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Removal is made more difficult if rib (2) is damaged!

Carefully pull out desiccant insert (1) with a pair of wide pliers on rib (2).

Fig 5: Pulling Out Desiccant Insert

G04792672

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

EVACUATE AND FILL A/C SYSTEM