33 52 Shock Absorbers
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - SHOCK ABSORBERS
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Nut and locknut/self-locking nut | F01/F02/F03/F04/F06/F10/F12/F13/F18 | M8 | Replace nuts. | 28 Nm |
| F07/F11 | M8 | Replace screws. | 28 Nm | ||
| F25/F26 | M8 | Replace screws. Jointing torque and angle of rotation must be observed without fail. |
|||
| Jointing torque | 25 Nm | ||||
| Angle of rotation | 45 ° | ||||
| 2AZ | Support bearing flange to shock absorber | F01/F02/F04/F06/F07/F10/F11/F12/F13/F18 | M12 | Replace nut. | 27 Nm |
| F25/F26 | M12 | Replace nut. | 34 Nm | ||
| 3AZ | Shock absorber to wheel carrier | F01/F02/F04/F06/F10/F12/F13/F18 | M16 | Replace screw. TIGHTEN DOWN IN NORMAL POSITION . |
250 Nm |
| F06 M6/F10 M5/F12 M6/F13 M6 | M14 | TIGHTEN DOWN IN NORMAL POSITION . | 165 Nm | ||
| 4AZ | Shock absorber to swinging arm | F07/F11 | M14 | TIGHTEN DOWN IN NORMAL POSITION . | 165 Nm |
| 5AZ | Spring strut to camber rod | F25/F26 | M14 | Replace screw and nut. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 90 ° | ||||