25 11 101 Replacing Gearshift Rod

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2016 BMW M5, 2016 BMW 535i, 2015 BMW M5, 2015 BMW 535i, and 2014 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove propeller shaft . See 26 11 000 REMOVING AND INSTALLING COMPLETE PROPELLER SHAFT (INSERTED - FLEXIBLE DISC AT REAR) or 26 11 000 REMOVING AND INSTALLING COMPLETE PROPELLER SHAFT (CONSTANT-VELOCITY JOINT) .

Detach retaining clip.

Fig 1: Detaching Retaining Clip

G04726003

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Retaining clip must interlock captively with retaining web (1) behind gearshift rod pin.

Fig 2: Retaining Web

G05778020

Courtesy of BMW OF NORTH AMERICA, INC.

Pull gearshift rod (1) out of gearshift rod joint (2).

Installation note:

Grease gearshift rod pin (3).

Grease, see OPERATING FLUIDS .

Fig 3: Pulling Gearshift Rod

G04726004

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retaining clip (1).

Remove gearshift rod (2).

Installation note:

Grease gearshift rod pin.

Grease, see OPERATING FLUIDS .

.

Fig 4: Retaining Clip And Gearshift Rod

G05778019

Courtesy of BMW OF NORTH AMERICA, INC.