16 13 522 Removing and installing/replacing temperature sensor for Natural Vacuum Leak Detection (NVLD)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Only unclip seat bench (1) as shown on the left and right and fold up in direction of arrow.

Secure seat bench on front seat (2).

Fig 1: Securing Seat Bench On Front Seat

Courtesy of BMW OF NORTH AMERICA, INC.

Fold both floor trim panels (1) to the side.

Unscrew nuts (2).

Remove cover for service opening (3).

Fig 2: Identifying Floor Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Carefully press tab (2) in direction of arrow.

Feed out temperature sensor (3) towards top.

Installation note:

Make sure latch mechanism of temperature sensor on flange cover is correct.

Fig 3: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.