12 51 100 Replacing wiring harness section for ignition and injectors (N55)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Read out the fault memory of the diagnostic development control unit
Switch off ignition
Disconnect BATTERY NEGATIVE LEAD
Remove IGNITION COIL COVER
Remove CLEAN AIR PIPE
Remove rear ignition coil cover

Unlock rear plug (1) from the control unit and disconnect.

Release rear wiring harness from intake plenum.

Fig 1: Identifying Rear Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and remove earth cable.

Tightening torque 12 90 5AZ .

Unlock all plugs from ignition coils and injectors and detach.

Unclip wiring harness (2), feed out and remove.

Fig 2: Identifying Wiring Harness And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Delete fault memory.