17 11 200 Removing And Installing/Replacing Engine Oil Cooler (S63 B44 T 0)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of scalding!
Only perform this repair work after engine has cooled down.
Only perform this repair work after engine has cooled down.
IMPORTANT:
Wear safety goggles and protective gloves.
Necessary preliminary tasks:
- Remove front UNDERBODY PROTECTION .
IMPORTANT:
Adhere to conditions of absolute cleanliness when repairing the engine oil circuit.
When removing engine oil pipes and engine oil cooler, seal off all openings with suitable plugs.
To avoid engine damage, do not allow any dirt particles to get into the engine oil circuit.
When removing engine oil pipes and engine oil cooler, seal off all openings with suitable plugs.
To avoid engine damage, do not allow any dirt particles to get into the engine oil circuit.
Recycling:
Engine oil escapes when engine oil pipes are released. Catch and dispose of emerging engine oil.
Observe country-specific waste disposal regulations.
Release screws (1).
Tightening torque: 17 22 4AZ .
Pull engine oil pipes off of engine oil cooler.
Catch and dispose of emerging oil.
Unfasten screws (2).
Tightening torque: 17 22 5AZ .
Remove engine oil cooler (3).
NOTE:
After the repair work is completed, check the oil level. Top up engine oil if necessary.