Removing and installing roof switch cluster (front) (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325

IMPORTANT: Follow notes for HANDLING LIGHT BULBS (INTERIOR LIGHTING) .

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip cover (1) with special tool 00 9 325 and remove.

Installation note:

Ensure cover (1) is correctly seated.

Unlock left/right retaining lugs (1) with screwdriver (2) in direction of arrow.

Remove roof switch cluster (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections underneath and disconnect.

Installation note:

Retaining lugs (1) must not be damaged.

Make sure roof switch cluster (3) is correctly fitted.

If necessary, initialize SLIDE/TILT SUNROOF .

IMPORTANT: Disconnecting the plug connection for the SOS emergency call button results in fault entries in the telephone control unit (restriction in the emergency call system).
After installation, read out fault memory and if necessary delete fault code entry.