Removing and installing or replacing alternator (B46/B48 4-Cyl. Engine) (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)

Necessary preliminary tasks: 

• Disconnect BATTERY NEGATIVE LEAD .
• Remove THROTTLE VALVE ASSEMBLY .
• Remove DRIVE BELT FOR ALTERNATOR .

In so doing:

• Do not  draw off air conditioning refrigerant.
• Do not  detach refrigerant lines from A/C compressor.
• Do not  remove air conditioning compressor; instead, release from bracket only and place to one side.

Removal: 

Slacken nut (1).

Feed out positive battery cable (2) and place to one side.

Unlock and disconnect plugs (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Loosen the alternator (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the alternator (1) towards the front in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the alternator (1) towards the top in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation for installation: 

Loosen the screws along the arrows.

Remove the tensioning device for the drive belt (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the tensioning device for the drive belt (1) on the new alternator.

Tighten the screws along the arrows.

Tightening torque 12 31 2AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Press back the threaded support sleeve (2) in the direction of the arrow to facilitate installing the alternator.

Screw in screw (1) into the threaded support sleeve (2). Turn back the threaded support sleeve (2) in the direction of the arrow using the screw (1).

Unscrew the screw (1) from the threaded support sleeve (2) again.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert the alternator (1) in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert the alternator (1) in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Install alternator (2).

Tighten down screws (1).

Tightening torque 12 31 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the positive battery cable (2) to the alternator.

Tighten nut (1).

Tightening torque 12 42 1AZ .

Attach connector (3).

Connector (3) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: 

• Install the AIR CONDITIONING COMPRESSOR .
• Install DRIVE BELT FOR ALTERNATOR .
• Install THROTTLE BODY .
• Connect BATTERY EARTH LEAD .