Remove transmission oil cooler
WARNING:
Hot fluids
.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
CAUTION:
Materials harmful to health
.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work:
- Remove right luggage compartment trim panel. Refer to REMOVING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES COUPE/CONVERTIBLE) or REMOVING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES GRAN COUPE SEDAN) .
- Refer to DISCONNECTING THE BATTERY EARTH LEAD .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING THE SUPPORT FOR THE UNDERBODY PROTECTION .
- Refer to REMOVING THE PROTECTIVE PLATE FOR THE FUEL LINES .
- Refer to DRAINING THE COOLANT FROM THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to DRAINING THE COOLANT FROM THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to UNINSTALLING THE COVER FOR THE DME CONTROL UNIT
- Refer to DISCONNECTING THE CONNECTOR FROM THE DME CONTROL UNIT AND FROM THE POWER DISTRIBUTION BOX (PDM) .
- Refer to REMOVING THE DME CONTROL UNIT
- Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Refer to REMOVING THE HOLDER FOR THE DME CONTROL UNIT
- Refer to REMOVING THE INTAKE PLENUM
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Unlock and loosen coolant line (1)
.
- Unlock and loosen transmission oil lines (1) .
- Unlock and loosen coolant line (2) .
- Loosen screws (3) .
- Loosen screw (4) .
- Remove the transmission oil cooler (5) .