Removing and installing/replacing left or right rear side window water drain (4' Series Convertible)

Necessary preliminary work:

Removal:

Undo seal plug (1).

Loosen latch mechanisms and press through the water drain (2) towards the inside.

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip and remove water drain (1) from side panel.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert water drain (1) and clip into side panel.

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Water ingress!
Insert water drain (1) in floor panel and make sure the latch mechanism engages correctly.

Installation note:

The seal plug is not installed again.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: