Installing the tension struts at the rear axle
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
- Install the left tension strut (5).
- Replace screws (4).
Parts: Screws
- Tighten the screws (4).
TIGHTENING TORQUE SPECIFICATIONS
| Rear tension strut to support | ||
| Replace screw. | Jointing torque Angle of rotation |
100 Nm 90° |
- Replace the screw (3).
Parts: Screws
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Rear tension strut to cross member of luggage compartment floor | |
| Replace screw. | 56 Nm |
- Replace the screw (2).
Parts: Screw
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATIONS
Rear tension strut to side member Replace screw. Jointing torque
Angle of rotation100 Nm
90° - Tighten the screws (1).
- Install the right tension strut (5).
- Replace screws (4).
Parts: Screws
- Tighten the screws (4).
TIGHTENING TORQUE SPECIFICATIONS
| Rear tension strut to support | ||
| Jointing torque Angle of rotation |
100 Nm 90° |
|
- Replace the screw (3).
Parts: Screw
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Rear tension strut to cross member of luggage compartment floor | |
| Replace screw. | 56 Nm |
- Replace the screw (2).
Parts: Screw
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Rear tension strut to side member | ||
| Replace screws. | Jointing torque Angle of rotation |
100 Nm 90° |
- Tighten the screws (1).