51 71 Gaskets And Loose Body Parts
51 71 GASKETS AND LOOSE BODY COMPONENTS - TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Rear spoiler | F01/F02/F04/F07 | Screw | 2 Nm | |
| Nut | 8 Nm | |||
| F11 | M8 | 8 Nm | ||
| F15/F85 | 6 Nm | |||
| F31 | 1.9 Nm | |||
| F45/F46/F48/F49 | Screw | 3.1 Nm | ||
| 2AZ Gasket to tailgate | F11 | 1.5 Nm | ||
| 3AZ Bulkhead upper part | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18 | Replace screws (Oval-head screw) |
5 Nm | |
| 4AZ Trim panel for cover on side member | F06/F12/F13 | 10 Nm | ||
| 5AZ Stiffening plate to luggage compartment floor | F34 | M8 | 19 Nm | |
| 6AZ Spoiler module to tailgate | F34 | 2.5 Nm | ||
| 7AZ Spoiler cover to retaining bracket | F34 | 8 Nm | ||
| 8AZ Retaining bracket of spoiler cover to spoiler module | F34 | 8 Nm | ||
| 9AZ Cross-strut to body | F15/F85 | Replace screws | ||
| Jointing torque | 10 Nm | |||
| Angle of rotation | 90° | |||
| 10AZ Support part for entrance to body | F15/F16/F85/F86 | 10 Nm | ||
| 11AZ Torsion cover to body | F33/F83 | Screw | 28 Nm | |
| Nut | 30 Nm | |||
| 12AZ Air duct to deformation element/cross connection | F45/F46/F48/F49 | Screw | 6 Nm | |
| 13AZ V-support to support/cross connection | F45/F46/F48/F49 | Screw | 12 Nm | |
| 14AZ Vertical connection to deformation element | F45/F46/F48/F49 | Screw | 12 Nm | |
| 15AZ Rear spoiler lower section to tailgate, top | F45/F48/F49 | Screw | 8 Nm | |
| 16AZ Rear spoiler lower section to tailgate, side | F45 | Screw | 4.5 Nm | |
| F48/F49 | Screw | 2.7 Nm | ||
| 17AZ Bulkhead cover, top | F45/F46/F52 | Screw | 3.0 Nm | |
| 18AZ Side trim on tailgate | F46 | Screw | 2.7 Nm | |
| 19AZ Wheel arch cover | F48/F49 | Screws and nuts | 3.0 Nm | |
| 20AZ Front spoiler on bumper | F06 M6/F13 M6 | 2 Nm |
| Connection carrier to body | ||
| M8 | 28 Nm | |
| Engine bulkhead to body | ||
| M8 x 18 | 19 Nm | |
| Engine bulkhead to bulkhead | ||
| Sheet metal nut | 2.6 Nm | |
| Partition wall attachment part to body | ||
| M6 x 20 | 2.3 Nm | |
| Tension strut with connecting support to body | ||
| M8 | 24 Nm | |
| Tension strut with connecting support to compression strut | ||
| M8 Replace screws |
Jointing torque Angle of rotation |
100 Nm 90° |
| Underbody panelling on body | ||
| Screw not metric thread | 3 Nm | |
| Screw M6 | 8.8 Nm | |
| Nut | 2.5 Nm | |