24 11 Transmission Case, Oil Sump
24 11 TRANSMISSION HOUSING, TRANSMISSION OIL SUMP - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Transmission oil sump | GA6HP19Z/GA6HP26Z/GA6HP32Z | M6 | 10 Nm | |
| 2AZ Oil drain plug | GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8P75H/GA8HP75Z | M 16x1.5 M24x1 M18x1 |
Plastic oil sump | 8 Nm |
| S63 GA8HP75Z | 12 Nm | |||
| 3AZ Oil filler plug | GA6HP26Z/GA6HP32Z | M30x1.5 | 80 Nm | |
| GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8HP90Z/GA8P75H/GA8P75HZ | M18x1.5 | Setpoint torque Calculation of adjusting torque: see: CHECKING/TOPPING UP OIL LEVEL IN AUTOMATIC TRANSMISSION (GA8HP50Z) |
35 Nm | |
| 4AZ Transmission oil sump | GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8HP90Z/GA8P75H/GA8P75HZ | M6 Replace aluminium screws; jointing torque and angle of rotation must be observed without fail. |
1) Jointing torque 2) Angle of rotation |
4 Nm 45° |
| Steel screws | 10 Nm | |||
| 5AZ Oil drain plug | GA8HP90Z | M10 | 12 Nm | |
| 6AZ Heat shield on gearbox | GA8HP45Z/GA8P70Z/GA8P75H | M8 | 19 Nm | |
| GA8HP45Z | M6 | 8 Nm | ||
| 7AZ Ground strap to body and transmission | GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8P75H | M8 | 19 Nm | |
| 8AZ Holder for underbody protection | GA8HP45Z | M6 | 8 Nm |