34 21 Rear Brakes

34 21 REAR BRAKE DISCS F32 - TECHNICAL DATA SPECIFICATIONS

IMPORTANT: Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension for "MIN TH" (see below). Brake discs must be replaced when they reach the nominal thickness minus 2.4 mm! (see below). (Not applicable to perforated brake discs and M vehicles)Applies only to M vehicles and perforated ventilated brake discs:The brake discs must be replaced once they wear to the nominal specified thickness minus 1.6 mm! (see below).Depending on: Engine type Transmission version Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.) different brake discs can be fittedThe brake discs must always be assigned by way of the relevant vehicle identification number and the applicable BMW parts catalogue!
Different thicknesses on brake linings	Max. mm	0, 01
Nominal size (diameter x thickness)	mm	300x20
(MIN TH) is stamped in brake disc chamber	mm	18, 4
Nominal size (diameter x thickness)	mm	330x20
(MIN TH) is stamped in brake disc chamber	mm	18, 4
Wear warning from residual lining thickness	mm	3, 7