Removing the cylinder head cover
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING CLEANING AIR PIPE .
- Refer to REMOVING FAN COWL .
- Refer to REMOVING THE COVER IN THE LEFT ENGINE COMPARTMENT .
- Refer to REMOVING THE RIGHT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE SOUND INSULATION ON THE BULKHEAD UPPER PART AT THE CENTER .
- Refer to REMOVING BOTH WIPER ARMS .
- Refer to REMOVING COWL PANEL COVER .
- Refer to REMOVING TRAILING LINK AT SPRING STRUT DOME .
- Refer to REMOVING ACOUSTIC COVER AT REAR .
- Refer to REMOVING IGNITION COILS .
- Refer to REMOVING THE HIGH PRESSURE LINE BETWEEN THE RAIL AND THE HIGH PRESSURE PUMP .
- Refer to REMOVING FUEL DELIVERY LINE .
- Refer to REMOVING THE INJECTORS FOR CYLINDERS 1 TO 3 .
- Refer to REMOVING THE INJECTORS FOR CYLINDERS 4 TO 6 .
- Refer to REMOVING HIGH PRESSURE PUMP .
- Refer to REMOVING BOTH ACTUATORS .
- Refer to REMOVING FRONT ENGINE ENCAPSULATION .
- Unclip the engine ventilation line (1)
.
- Unlock, disconnect and release both connectors (1)
from the wiring harness (2)
.
- Loosen screw (1) and lay the fuel delivery line (2) to one side.
- Unclip wiring harness (3) in marked area and place to one side.
- Unclip wiring harness (4) in marked area and place to one side.
- Undo screw (5)
and set aside the holder with the positive battery cable.
- Unlock and disconnect connector (1) .
- Unclip wiring harness (2)
in marked area and place to one side.
- Unlock and disconnect connector (1) .
- Unclip wiring harnesses (2)
and (3)
in marked area and place to one side.
- Loosen all screws in sequence (21) to (1) .
- Remove cylinder head cover.