Removing the servomotor for the eccentric shaft
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE THROTTLE BODY .
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
RISK OF DAMAGE
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .
- Adhere to the utmost cleanliness.
- Protect components from contamination e.g. by covering.
- Close off line connections with seal plugs.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Unlock ventilation line (1) and detach from intake plenum.
- Unlock connector (2)
and detach.
- Motor oil may leak when detaching the servomotor, keep cleaning cloth ready.
- Loosen screws (1)
.
- Turn servomotor (1) on the screw in marked area towards the left in order to release the eccentric shaft.
- Detach the servomotor (1) from the cylinder head simultaneously.
- Turn wave maximum up to the end stop towards the left.