Installing servomotor for the eccentric shaft

• Replace seal (1)  .

  Parts:  Gasket

  Courtesy of BMW OF NORTH AMERICA, INC.

• Press the seal (1)  up to the limit position on the housing.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Grease the gearing (1)  of the servomotor for eccentric shaft (2)  in the marked  area.

  Parts:  lubricating grease

  CONSUMABLE DESCRIPTION
  
  

  Lubricating grease Longtime PD-1

  400 g, Cartridge

  83192160340

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clean sealing surface (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert servomotor (1)  till the gearing is lined up.
• Turn the servomotor (1)  in the marked area to the right with conventional tools until it rests against the cylinder head.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Servomotor for the eccentric shaft to cylinder head
  M6 x 16	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock connector (2)  .
• Position the ventilation line (1)  on the intake plenum and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up works 

• Refer to INSTALLING THE THROTTLE BODY .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING ACOUSTIC COVER .
• Version with eccentric shaft servomotor: Teach in the end stops using the appropriate diagnostic system / scan tool.