Removing and installing/replacing front side panel trim on left or right (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)
Special tools required:
- 00 9 327
The trim is secured with double-sided adhesive tape and can not be reused after disassembly.
Observe NOTES FOR SECURING COMPONENTS WITH ADHESIVE TAPE .
Tape off side panel above trim (1) with yellow plastic adhesive tape.
Release trim (1) from latch mechanisms (2) with special tool 00 9 327 .
Release double-sided adhesive tape in area (A) and remove trim (1).
Installation note:
Replace faulty clips (3).
Clean bonding surface.
Installation note:
Pull off liner (1).
Place trim (2) on side panel, clip in at top and press down evenly on adhesive tape.