Replace rear bumper panel (4' Series Coupe, 4' Series Gran Coupe Sedan)
Attention!
To ensure the system function in vehicles with sensor for lane change warning (optional equipment S5ASA and S5ATA), do not repaint the bumper panel in paint stage 1 or paint stage 3.
Do not attach labels in the sampling range of the sensor.
Follow the further instructions according to painting manual.
Necessary preliminary work:
- Remove BUMPER PANEL .
- Remount the cover for the towing eye
- If necessary, punch HOLES FOR ULTRASONIC SENSORS .
- If necessary, install HOLDER FOR ULTRASONIC SENSORS .
- Remount REAR REFLECTORS .
Execution with PDC:
Unlock retaining tabs (1) in direction of arrow and pull ultrasonic sensor (2) up and out of bracket (3).
Installation note:
Before installing the ultrasonic sensor (2), clean the plug connections.
Retaining tabs (1) must not be damaged!