REP-TAT-P-1214-01 Removing the DME control unit
NOTE:
TECHNICAL INFORMATION
Follow instructions for removing and installing control units.
For additional information see: NOTES ON REMOVAL AND INSTALLATION OF CONTROL UNITS
Follow instructions for removing and installing control units.
For additional information see: NOTES ON REMOVAL AND INSTALLATION OF CONTROL UNITS
NOTE:
TECHNICAL INFORMATION
In a warranty case, you must always provide a fault memory printout with the defective part, even if the fault memory does not contain an entry.
In a warranty case, you must always provide a fault memory printout with the defective part, even if the fault memory does not contain an entry.