REP-TAT-P-1137-02 Installing all gates

Have the special tool 2 359 089 ready.

Courtesy of BMW OF NORTH AMERICA, INC.
Clean contact surfaces (1) and (2) off oil, grease and dirt.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the gate (2) and hand-tighten the screw (1).
Make sure the intermediate lever (3) is in the correct installation position.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the special tool 2 359 089 on the cylinder head.
Pre-tension the gate with the lever (3).
Abut the screw (1) in the area (2).
Make sure that the special tool 2 359 089 does not rotate during this process.

Courtesy of BMW OF NORTH AMERICA, INC.
Secure the gate with the lever (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Ensure that the special tool 2 359 089 lies flat on the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.
Press the special tool 2 359 089 onto the cylinder head.
Tighten the screw (1) at the same time.

TIGHTEN TORQUES SPECIFICATIONS

Gate to bearing bracket
M7 tightening torque	20 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Technical data

Gap dimension between gate and bearing bracket
Gap dimension A		0.03 mm

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure the gate (1) lies correctly against the bearing bracket (2).
The gate (1) is correctly installed in the marked area.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure the gate (1) lies correctly against the bearing bracket (2).
The gate (1) is not correctly installed in the marked area.

Courtesy of BMW OF NORTH AMERICA, INC.
Repeat the procedure for all gates.