Removing and installing lower right engine bulkhead

Removal: 

Release screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Remove engine bulkhead (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove partition wall (2) attachment.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Position partition wall (2) attachment.

Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Position engine bulkhead (2).

Tighten down nuts (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque: 19 Nm.

Courtesy of BMW OF NORTH AMERICA, INC.