REP-TAT-P-1137-05 Checking the position of the intake camshaft at cylinders 3 and 4 (cylinder head removed)

Check 

• Check the position of the intake camshaft at cylinder 3 and 4.

  To remove the torsion springs on cylinders 3 and 4, the camshaft sensor wheel (1) of the intake camshaft must be in the position shown.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» The camshaft sensor wheel (1) of the intake camshaft is not in the position shown.

Measure

• Continue to crank the intake camshaft on the mounting flats.