REP-TAT-P-1137-01 Remove torsion springs
CAUTION:
Spring preload.
Injury hazard!
Injury hazard!
- The use of the specified special tool (tool) is mandatory.
- The described operation must be carried out properly.
NOTE:
TECHNICAL INFORMATION
Wear safety goggles.
Wear safety goggles.
NOTE:
The description is for one component only. The procedure is identical for all further components.
- Get the set of special tools 2 359 088
ready.
Number Description 1 Clamping lever 2 Mount for the clamping lever (assembly aid) - Open the special tool 2 359 088
and position it at the torsion spring (1).
- Ensure that the special tool 2 359 088 lies flat in the area (1) on the cylinder head.
- Carefully close the clamping lever of the special tool 2 359 088 until the safety catch (2) engages.
Check
- Check if the special tool 2 359 088 is positioned correctly on the torsion spring.
Result
» Special tool 2 359 088 is not positioned correctly on the torsion spring.
Measure
- Carefully release the clamping lever of the special tool 2 359 088 and repeat the process.
- Clamp the mount (1) of the special tool 2 359 088 in the vice (2).
- Position the clamping lever (3) of the special tool 2 359 088 with the pre-tensioned torsion spring (5) in the direction of the arrow in the mount (1) of the special tool 2 359 088 .
- Carefully unlock the snap-in hooks (4) of the special tool 2 359 088
.
The torsion spring (5) relaxes.
- Slowly open the clamping lever (3) and remove the torsion spring (5).
- Place torsion spring (5) neatly in special tool 0 495 105 (11 4 480) .
- Repeat the steps for the remaining torsion springs.