REP-TAT-P-1112-01 Removing the cylinder head cover

• Unclip the engine ventilation line (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock, disconnect and release both connectors (1) from the wiring harness (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screw (1) and lay the fuel delivery line (2) to one side.
• Unclip wiring harness (3) in marked area and place to one side.
• Unclip wiring harness (4) in marked area and place to one side.
• Undo screw (5) and set aside the holder with the positive battery cable.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect connector (1).
• Unclip wiring harness (2) in marked area and place to one side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect connector (1).
• Unclip wiring harnesses (2) and (3) in marked area and place to one side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen all screws in sequence (21) to (1).
• Remove cylinder head cover.

Fig 1: Cylinder Head Cover Screws Loosening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.