REP-TAT-P-1112-05 Checking cylinder head for watertightness
- Position the cylinder head (1) on the special tool 2 361 215 and tighten with the enclosed (short) screws.
- Remove the venting connector.
- Install the special tool 2 410 136 (valve).
TIGHTEN TORQUES SPECIFICATIONS
| Venting connector/special tool to cylinder head | ||
| M10 Replace the venting connector! |
Tightening torque | 18 Nm |
- Make sure that the pressure does not exceed 3 bar.
- Heat up the cylinder head to 60 degrees in a water bath.
- Visually inspect for a loss of pressure in the water bath.
- Remove all special tools.
- Install the venting connector.
TIGHTEN TORQUES SPECIFICATIONS
| Venting connector/special tool to cylinder head | ||
| M10 Replace the venting connector! |
Tightening torque | 18 Nm |