REP-TAT-P-1100-05 Check compression of all cylinders
- Unscrew sensor 1 from special tool 0 490 615 (11 0 222) .
- Check the secure fit of the valve below.
- Prepare special tool 0 490 615 (11 0 222) in conjunction with the special tool 0 496 306 (11 8 732) and 0 496 107 (11 8 730) .
- Screw special tool 0 490 615 (11 0 222)
with 10 Nm
on the special tool 0 496 107 (11 8 730)
.
- Connect special tool 2 410 242 to special tool 0 490 613 (11 0 220) with the bayonet closure.
- 100-bar sensor
100-bar sensor
100-bar sensor
81 31 2 357 801
1 Screw hand-tight into special tool 2 410 242 .
- 100-bar sensor
100-bar sensor
100-bar sensor
81 31 2 357 801
1 Connect with the IMIBR2
IMIBR2
IMIBR2
81 38 2 295 937
.
- Manually screw the special tool 0 490 615 (11 0 222)
with the special tool 0 496 305 (11 8 731)
into the spark plug thread.
- Observe diagnosis instructions.