31 12 000 Removing and installing/replacing left or right wishbone
NOTE:
If the wishbone is detached from the front axle support, it will be necessary to carry out the WHEEL ALIGNMENT PROCEDURE
.
Necessary preliminary tasks:
- Refer to REMOVING FRONT WHEEL
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION
Only on ride-height sensor at left:
Release link at wishbone.
Release nut (1), if necessary, grip at inner Torx socket.
Tightening torque 31 12 4AZ .
Installation note:
Keep wishbone to swivel bearing connection clean and free from oil and grease.
Replace self-locking nut.
Slacken nut (2).
Tightening torque 31 12 3AZ .
Remove screw towards front.
Take off wishbone.
Installation note:
Replace screw and nut.
Bolt head points in direction of travel.
Tighten down SCREW CONNECTION in normal position.
After installation:
- Carry out WHEEL ALIGNMENT PROCEDURE .