REP-TAT-P-1354-02 Installing the throttle body
- Connect and lock the connector (1) on the throttle body (2).
The connector (1) must engage audibly.
- Feed in and install the throttle body (1).
- Replace gaskets.
Parts: Seals
- Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Throttle body to intake plenum | ||
|---|---|---|
| 6X50 | tightening torque | 7 Nm |
- Insert and install charge air line (5).
- Tighten down screws (4).
Tightening torques
| Charge air line to throttle valve | ||
|---|---|---|
| M6x30 | tightening torque | 8 Nm |
- Connect connectors (3) and lock.
- Connect connectors (2) and lock.
- Connect connectors (1) and lock.
All connectors must audibly engage.