REP-TAT-P-1123-02 Installing the vibration damper
NOTE:
TECHNICAL INFORMATION
When removing/refitting or replacing the vibration damper, the radial shaft seal must also be replaced.
When removing/refitting or replacing the vibration damper, the radial shaft seal must also be replaced.
- Clean oil and dirt off sealing surface (1).
Check
- Check if the special tool 0 496 595 (11 6 130) is installed correctly.
Result
» Special tool 0 496 595 (11 6 130) not fitted.
Measure
- Install special tool 0 496 595 (11 6 130) , remove vibration damper.
- Install vibration damper (2) from the top and position correctly.
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Vibration damper to crankshaft | ||
|---|---|---|
| M10 x 65 Replace screws. |
Joining torque | 40 Nm |
| Angle of rotation | 120° | |
- Remove special tool 0 496 595 (11 6 130) .