Stripping Operations - Replacing Luggage Compartment Floor And Right Side Member (Right Side Panel And Tail Panel Removed)
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
The following list basically represents the removal sequence.
- Remove exhaust system (job number: petrol engine 18 00 020, diesel engine 18 00 018)
- Remove exhaust system heat shield
- Remove rear axle support (job number: 33 31 000)
Remove cover (1) and release nut (2) below it.
Tightening torque: refer to BATTERY WITH TERMINAL .
Turn the lock (2) counterclockwise and remove.
Push the positive battery wire connector (1) through the luggage compartment floor to the outside.
Release plug connection (1) on power distribution box.
Release positive wire (2) on mounting (3) and press grommet (4) through to the outside with positive battery cable.
Unlock plug connections (1) and disconnect.
Release nut (2) and remove POSITIVE BATTERY CABLE DISTRIBUTOR (3).
Tightening torque: refer to BATTERY WITH TERMINAL .
Release wiring harness (4) from retaining pin.
Partially release the insulating mat (5) and set aside.