REP-TAT-P-5148-02-01 Installing the sound insulation on the rear door
NOTE:
TECHNICAL INFORMATION
Notes on the sound insulation must be strictly observed for these repair instructions.
For additional information see:NOTES FOR BONDING SOUND INSULATION (SI), DOORS
Notes on the sound insulation must be strictly observed for these repair instructions.
For additional information see:NOTES FOR BONDING SOUND INSULATION (SI), DOORS
Reinstalling the sound insulation (rear door)
- Check the sound insulation (2) for damage and replace if necessary.
- Route the butyl rope with Ø 4 mm (sourcing reference BMW Group Parts) along the previous routing of the butyl rope (1).
Replacing the sound insulation
NOTE:
TECHNICAL INFORMATION
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
- Remove any butyl rope residue from the door and clean the adhesive area.
- Observe 1 min air drying time.
- Attach the 6 mm butyl rope (3) (sourcing reference: BMW Group Parts) on the mark (2) of the sound insulation (1).
- Heat up the butyl rope (1) with the hot air blower and press on the sound insulation (4) all around using a hand roller.
- Route lines (3) and connect the connector (2).
Follow-up work
- Install the LEFT OR RIGHT REAR DOOR TRIM PANEL
- Install the COVER ON THE REAR LEFT OR RIGHT DOOR HANDLE
- Install the REAR POWER WINDOW SWITCH